This FrSKY accessory will enable you to set up a 2.4GHz wireless trainer system between any Futaba transmitter with a 6-pin square trainer port (used as the trainer/teacher/master transmitter) and a Futaba FASST transmitter (used as the trainee/pupil/slave transmitter).
The master transmitter does not necessarily need to be FASST compatible but it must be a Futaba transmitter with the 6-pin square trainer port. The slave transmitter must be a Futaba FASST transmitter.
The wireless link is established using an FrSky TFRSP receiver. The WTC-1 lead is used to connect the trainer port of the master transmitter to the TFRSP CPPM port.
In essence, the master transmitter is setup to control the model. The TFRSP receiver is linked/bound to the slave transmitter. Signals from the slave transmitter are received by the TFRSP and fed into the master transmitter via the WTC-1 cable.
As with any 'buddy-box' system, it is essential to establish correct control and operation of the aircraft on the ground, with particular attention to channel allocation.
* Connector Type: Futaba 6-pin square
* Lead Length: 160mm
* Weight: 6g
The FrSKY TFRSP FASST Compatible 2.4GHz 10-Channel Receiver can be found under stock no. 406824
Full instruction are supplied with the WTC-1. For further information - click here